EDTA Antigen Retrieval Buffer (pH8.0, 1X), 1 L

$99.00

Add to Wishlist
Add to Wishlist

Description

EDTA Antigen Retrieval Buffer ( pH 8.0, 1×) is a special solution that enables rehydrate and target retrieval in formalin-fixed, paraffin-embedded tissue sections in one step. It is optimal for use with primary antibodies that require EDTA buffer (pH=8.0) pretreatment.

Application

Antigen retrieval buffer used with primary antibodies that require EDTA buffer (pH=8.0) pretreatment.

Contents

EDTA Antigen Retrieval Buffer (1×), pH 8.0————1 L

Storage

Store at room temperature

Procedure

  1. Deparaffinize sections in 2 changes of xylene, 5 minutes each.
  2. Hydrate in 2 changes of 100% ethanol for 2 minutes each, 95% and 75% ethanol for 2 minute each. Then rinse in distilled water.
  3. Pre-heat steamer or water bath with staining dish containing 1× EDTA Buffer until temperature reaches 95-100 °C.
  4. Immerse slides in the staining dish. Place the lid loosely on the staining dish and incubate for 15 minutes (optimal incubation time should be determined by user).
  5. Turn off steamer or water bath and remove the staining dish to room temperature and allow the slides to cool for 20-40 minutes.
  6. Rinse sections in PBS Tween 20 for 2×2 min.
  7. Proceed to standard immunohistochemistry protocol.

Note 1: Microwave, pressure cooker and autoclave can be used as alternative heating source to replace steamer or water bath.

Note2: This product is intended for research purposes only. This product is not intended to be used for therapeutic or diagnostic purposes in humans or animals. Avoid contact with eyes, skin and clothing. Do not ingest. Wear gloves.

User Manual (PDF)

VB-6008 user manual

VB-6008 MSDS

Frequently Asked Questions

What is this product used for?

Antigen retrieval in immunostaining. It enables rehydration and target retrieval in formalin-fixed, paraffin-embedded tissue sections in one step, and is optimal for use with primary antibodies that require EDTA buffer (pH 8.0) pretreatment.

Do I need to dilute it before use?

No. This is a ready-to-use 1× formulation of EDTA Antigen Retrieval Buffer (pH 8.0) — use it directly in the staining dish without dilution.

What are the key steps in the procedure?

Deparaffinize sections in 2 changes of xylene, 5 minutes each, then hydrate through 100%, 95%, and 75% ethanol and rinse in distilled water. Pre-heat a steamer or water bath with a staining dish containing 1× EDTA Buffer until the temperature reaches 95–100 °C, immerse the slides with the lid loosely on, and incubate for 15 minutes (the optimal incubation time should be determined by the user). Let the slides cool for 20–40 minutes at room temperature, rinse in PBS Tween 20 for 2×2 minutes, and proceed to the standard immunohistochemistry protocol.

What heating sources can I use for antigen retrieval?

A microwave, pressure cooker, or autoclave can be used as an alternative heating source to replace the steamer or water bath.

How should I store it?

At room temperature.

Is this product for diagnostic use?

No. It is intended for research purposes only, and is not intended for therapeutic or diagnostic use in humans or animals. Avoid contact with eyes, skin and clothing, do not ingest, and wear gloves.